TM 9-2350-222-20-1-3
ENGINE COOLING FAN REPLACEMENT (Sheet 3 of 4)
Using slip joint pliers, remove 16 cotter pins (G)
6.
and throw away.
7.
Using 1/2 inch socket and wrench, remove 16
nuts, bolts, and washers (H) holding fan (J) to
hub (K).
Place block of wood on hub (K). Using
8.
hammer, strike block of wood until hub is
separated from fan (J).
9.
Inspect hub (K) for damages. Replace hub if
damaged.
INSTALLATION:
1.
Position hub (A) on fan (B), machined surface
up (marked TOP).
2.
Using 1/2 inch socket and wrench, install 16
bolts, nuts, and washers (C). Using torque
wrench, tighten nuts to 15-20 lb-ft (20-27 N-m).
3.
Using slip joint pliers, install 16 new cotter pins
(D).
TA140283
Go on to Sheet 4
9-49
