TM 9-2360-222-20-1-3
TRANSMISSION SHROUD REPAIR (Sheet 3 of 6)
6.
Using diagonal cutting pliers, remove lockwire (L) from 25 screws (M) on back side of retainer (N).
7.
Using hammer and chisel, bend tabs on four key washers (P) away from screw heads.
NOTE
If desired, speed wrench may be used to remove screws (M).
8.
Using 7/16 inch socket, remove 25 screws (M) four key washers (P), and 21 flat washers
holding retainer (N) to shroud (E). Throw key washers away.
9.
Remove retainer (N) from shroud (E).
10. Remove insulation (Q) from shroud (E).
TA140262
Go on to Sheet 4
9-28
