TM 9-2350-222-20-1-3
TURBOCHARGER SHROUDS REPLACEMENT (Sheet 2 of 6)
Inner Shroud Replacement (Sheet 2 of 4)
NOTE
Procedures for replacement of the
left or right turbocharger shrouds
are similar. Procedures for the left
side are shown.
REMOVAL:
1.
Using 11/16 inch wrench, disconnect hose
assembly (A) from turbocharger elbow (B).
2.
Using 1/2 inch socket, remove two screws and
washers (C) securing inner shroud (D) to
turbocharger plate.
3.
Using 1/2 inch socket, remove two screws and
washers (E) securing inner shroud (D) to
turbocharger plate.
4.
Using 1/2 inch wrench and 1/2 inch socket,
remove screw and self-locking nut (F)
securing inner shroud (D) to upper shroud
(G). Throw self-locking nut away.
5.
Using 1/2 inch socket, remove three screws
and washers (H) securing inner shroud (D) to
oil cooler frame.
6.
Remove hose assembly (A) and grommet (J)
from inner shroud (D).
7.
Remove inner shroud (D).
8.
Remove grommet (J) from hose assembly (A).
Throw grommet (J) away.
TA140251
Go on to Sheet 3
9-14