TM 9-2350-222-20-1-3
RIGHT EXHAUST EJECTOR TUBE REPLACEMENT (Sheet 3 of 4)
INSTALLATION:
Position insulation (A and B) to ejector
1.
tube (C).
Using cross-tip screwdriver and 5/16
inch wrench, install 11 screws (D), 22
flat washers (E), 11 new lockwashers
(F), and 11 nuts (G) to secure insulation
(A) and (B) to ejector tube (C).
Position packing (H) and clamp (J) onto
ejector tube (C). Use flat-tip screwdriver
to tighten clamp (J).
Apply coating of silicone compound
4.
(Item 32, Appendix C) to end of hose (K).
5.
Position ejector tube (C) and new gasket
(L) onto studs of turbosupercharger (M)
and hose (K).
Using 9/16 inch wrench, install six new
6.
self-locking nuts (N) to secure ejector
tube (C) to turbosupercharger (M).
ENGINE RIGHT BANK
Go on to Sheet 4
TA249112
8-27
Change 2
