TM 9-2350-222-20-1-3
LEFT EXHAUST EJECTOR TUBE REPLACEMENT (Sheet 1 of 4)
PROCEDURE INDEX
PROCEDURE
PAGE
Removal
Installation
No. 1 cross-tip screwdriver
TOOLS:
9/16 in. open end wrench
5/16 in. combination box and open end wrench
1/2 in. combination box and open end wrench (two required)
S c r e w d r i v e r , flat-tip, 1/4 in.
SUPPLIES:
Lockwasher (MS35335-58) (11 required)
Gasket (10864007)
Self-locking nut (SPL51712-6) (6 required)
Silicone compound (Item 32, Appendix D)
Self-locking nut (MS21045-5)
PRELIMINARY
PROCEDURE:
REMOVAL:
Using flat-tip screwdriver, loosen two
1.
clamps (A).
Using two 1/2 inch wrenches, hold self-
2.
locking nut (B) and remove screw (C)
securing clamp (D) to left ejector tube
bracket (E). Discard self-locking nut.
ENGINE LEFT BANK
Go on to Sheet 2
TA249106
8-21