TM 9-2350-222-20-1-3
OIL FILLER TUBE AND HOSE (LOWER) REPLACEMENT (Sheet 1 of 2)
TOOLS:
5/16 in. socket with 1/2 in. drive
5 in. extension with 1/2 in. drive
1/2 in. combination box and open end wrench
Putty knife
Ratchet with 1/2 in. drive
Goggles (Item 74, Appendix D)
SUPPLIES: Gasket
Rubber gloves (Item 73, Appendix D)
Rags (Item 65, Appendix D)
Dry cleaning solvent (Item 54, Appendix D)
Lockwasher (3 required)
PRELIMINARY PROCEDURE: Remove powerplant (page 5-1)
WARNING
Dry cleaning solvent P-D-680 is
toxic and flammable. Wear pro-
tective goggles and gloves and use
only in a well-ventilated area.
.
Avoid contact with skin, eyes, and
clothes and don't breathe vapors.
Do not use near open flame or
excessive heat. The flash point
for Type #1 Dry Cleaning Solvent
is 100F (38C) and for Type #2 is
140 F (60C).
If
you become
dizzy while using cleaning sol-
v e n t , get fresh air immediately
and get medical aid. If contact
with eyes is made, wash your eyes
with water and get medical aid
immediately.
NOTE
Using dry cleaning solvent and rags, clean all parts and general
REMOVAL:
area prior to removal.
1.
Using socket, loosen two clamps (A) from hose (B).
2.
Using 1/2 inch wrench, remove three screws (C) and lockwashers (D) from tube assembly (E).
Throw lockwashers away.
3.
Pull tube assembly (E) and hose (B) loose and slip off two clamps (A).
4.
Using putty knife, remove gasket (F) and throw away.
Go on to Sheet 2
Change 4
6-47
