TM 5-5420-226-20-1 Svmdom- 41 DETAILED TROUBLESHOOTING PROCEDURE INDICATOR -   LAMP (Continued) ~ Check POWERPLANT WARNING LAMP    for continuity. Second Technician’s (Operator’s Station) l   Set    MASTER BATTERY switch OFF. First Technician (Commander’s Station) l   Install    front   accessory harness connector at bulkhead disconnect (page 10-270). Second Technician (Operator’s Station) l   Disconnect front accessory harness connector from POWERPLANT WARNING LAMP connector. l   Set   multimeter to   OH,MS X  1  scale    and “zero” meter, or   use   STE/ICE Test No. 91   (page 4-83). l   Connect two    probes of   meter to   the    two    contacts of POWERPLANT WARNING LAMP connector. l   Check    if   meter    indicates continuity. Does    meter indicate continuity? m _o^l   02^@ O:f’- “‘;: = .- -.    ‘4. --- 0- .0 &!- =(at=”— / . POWERPLANT L WARNING LAMP \ 7^{CKT    27TIE   POINT}  I Replace POWERPLANT WARNING LAMP    assembly (page 10-189). . r FOR   CLARITY QUADRANT ‘ ASSEMBLIES NOT   SHOWN l   Inspect    basket-indicator panel l l l harness for   benthroken” conqector contacts or   loose CKT   509L   wire   at   rear   of connectors. Repair    connectors if  defective (page 10-298). If  connectors are   not defective, notify support maintenance of   a  defective basket-indicator panel harness. Connect front    accessory harness connector to POWERPLANT WARNING LAMP. .— TA107188 4-499