3. Remove air filter element (4) by pulling on tab (3) at
the top or bottom of the filter.
4. Inspect filter element (4) for plugging or damage.
NOTE: If filter element (4) is excessively dirty or
damaged, notify Unit Maintenance that the filter
element must be cleaned or replaced.
5. Clean the filter chamber with a damp cloth.
6. Install filter element (4).
7. Install the filter bracket and close latch (2) at the
bottom of the filter bracket.
8. Close access panel (1).
Internal Filter
1. Remove bolt and open access door (1) at the front
of the blower assembly.
2. Remove the filter elements.
NOTE: There are two filter elements installed together.
3. Inspect the filter elements for plugging or damage.
NOTE: If the filter elements are excessively dirty or
damaged, notify Unit Maintenance that the filter
elements must be cleaned or replaced.
4. Clean the filter chamber with a damp cloth.
5. Install the filter elements.
6. Close access door (1) and install the bolt.
1
3
4
109
Maintenance Section
When Required
TM5-2430-200-10
