Cylinders, Accumulators and Hoses
Inspect suspension cylinders (6), accumulators (7),
and visible hoses for leaks large enough to form
drops. Use a soft cloth to remove any dirt from the
cylinder rods. Check for loose or missing fasteners. If
leaks or loose or missing fasteners are found on any
component, inform Unit Maintenance.
Drive Wheels and Scraper Bars
Inspect drive wheel (8). Have Unit Maintenance repair
or replace the drive wheel/hub if any of the following
conditions are met:
• More than two drive slats in a row, more than four in
a group of ten, or more than six total, are missing
from a single drive wheel.
• Oil is leaking from the hub severely enough to form
drops.
• There are loose of missing mounting bolts.
Inspect scraper bars (9) for damage and loose or
missing fasteners. Notify Unit Maintenance to repair or
replace the scraper bar if it is bent, the rubber flaps
are missing, or if any bolts are loose or missing.
Pin Retention Bolts
Inspect undercarriage pins (10) for loose or missing
retention bolts. Inform Unit Maintenance if any loose or
missing retention bolts are found.
Belt Guides
Inspect belt guides (11) for wear and loose or missing
bolts. Notify Unit Maintenance if the belt guides are
worn enough for holes to form, or if the bolts are loose
or missing.
11
10
10
10
8
9
6
7
7
113
Maintenance Section
Every 10 Service Hours or Daily
TM5-2430-200-10
