TM 5-2350-262-20-2
4-894.14 Change 3
REMOVAL
A Remove two screws (1), lockwashers (2), and
washers (3) from shift control assembly (4), and
move shift control assembly (4) away from
driver’s compartment wall. Place shift control
lever (5) in N (neutral). Discard lockwashers
(2).
B Remove access cover (6).
C Loosen jamnut (8) and setscew (7), and turn
shift control assembly (4) counter-clockwise
until shift control cable (9) is free.
INSPECTION
Inspect plastic boot on shift control cable (9) for
cuts, breaks, or deterioration. Replace shift
control cable (9) (p 4-894.10) if boot is damaged.
INSTALLATION
A Insert threaded end of shift control cable (9)
into shift control assembly (4). Turn shift control
assembly (4) clockwise to secure shift control
cable (9) to pin (10) inside shift control assembly
(4).
B Lock shift control cable (9) in place by tightening
setscrew (8) in cable groove (10). Lock setscrew
(7) by tightening jamnut (8).
C Install access cover (6).
D Install shift control assembly (4) to driver’s
compartment wail with two washers (3),
lockwashers (2), and screws (1).
FOLLOW-ON TASK:
Adjust winch shift control lever (p 4-894.8).
4
3
2
1
DRIVER’S
COMPARTMENT
WALL
