TM 5-2350-262-20-2
4-894.12 Change 3
INSTALLATION
A Install shift control cable (1) on vehicle by routing
cable through hole (2) in floor of driver’s
compartment, along left side of winch (3), and
across back of winch (3)
B Place shift control lever (4) in N (neutral), and
insert end of shift control cable (1) into pin (5) of
shift control assembly (6). Turn shift control
assembly (6) clockwise until cable (1) is tight.
C Lock shift control cable (1) in place by tightening
setscrew (7) down on cable groove (8). Lock
setscrew (7) by tightening jamnut (9). Install
access cover (10).
D Install shift control assembly (6) on driver’s
compartment wall with two washers (11),
lockwashers (12), and screws (13).
E Move shift control cable (1) to installed position
on cable mount (14) and secure with clamp (15)
and two nuts (16).
F Assemble shift control cable (1) to control lever
(17) and secure with clevis pin (18) and cotter
pin (19).
FOLLOW-ON TASKS:
• Adjust winch shift control lever (p 4-894.8).
• Install rear floor plates (p 4-360).
11
6
DRIVER’S
COMPARTMENT
WALL
12
13
