ENGINE DISCONNECT LEAD ASSEMBLY REPLACEMENT (2A ENGINE) (Sheet 3 of 4)
1. Place engine disconnect lead assembly in position in
2. Place three covers (A) in position.
3. Using 7/16 inch wrench, install screws (B),
lockwasher (C), and flat washer (D) into covers (A).
4. Place clamp (E) (hidden by bulkhead) in position.
5. Using 7/16 inch wrench, install screw (F) and
6. Place strap (H) in position.
7. Using 7/16 inch wrench, install screw (J), lockwasher
(K), and flat washer (L).
Go on to Sheet 4