ENGINE DISCONNECT LEAD ASSEMBLY REPLACEMENT (2A ENGINE) (Sheet 2 of 4)
Straps and covers should be left in place by
removing only one screw. If replacement of
strap is required, remove both screws.
3. Using 7/16 inch wrench, remove screw (C),
lockwasher (D), and flat washer (E) from
4. Using 7/16 inch wrench, remove screw (G)
and lockwasher (H) (hidden by bulkhead).
5. Remove clamp (J).
6. Using 7/16 inch wrench, remove screw (K),
lockwasher (L), and flat washer (M) from three
7. Remove engine disconnect lead from vehicle.
Go on to Sheet 3