Position rear engine access cover (C) in place under front access cover (D) on engine.
Install 14 assembled washer screws (E) using 1/2 inch socket, tighten 14 screws (E).
Install new gasket (F) on control cable (G).
Install control cable (G) through hole in
Install shakeproof washer (H) and nut (J) on
control cable (G).
Using adjustable wrench, tighten nut (J). Use
1-1/8 inch wrench to hold control cable at
flange (K) while tightening nut (J).
Go on to Sheet 6