TM 9-2350-222-20-1-5
INNER EXHAUST PIPE REPLACEMENT (Sheet 2 of 2)
INSTALLATION:
1.
Install insulation (A) over hose part of pipe (B).
Slide clamp (C) into position on pipe (B).
2.
3.
Using hammer, lightly tap flange (D) onto
exhaust elbow end of pipe (B).
4.
Using hammer and chisel, tap sleeve (E), with
tapered end of sleeve away from flange (D), onto
pipe (B).
NOTE
Sleeve (E) butts up to flange (D) to hold flange in place. It may
be necessary to use hammer and punch to aid in mating the
two flanges.
5.
Position heater pipe (B) to exhaust elbow (F) so
flange (D) mates to flange on elbow.
Slide clamp coupling (G) over mating flanges.
Install nut (H) onto coupling (G). Using
wrench, tighten nut (H).
7.
Using socket, tighten screw (J) with new lockwasher (K) securing clamp (C) to hull.
8.
End of Task
TA141228