TM 9-2350-222-20-1-5
REMOVAL:
1.
Using pliers, remove cotter pin (A). Throw
cotter pin away.
Remove pin (B) to release clevis (C) from
2.
Using 9/16 inch wrench, remove two screws
3.
Using 7/16 inch wrench, loosen nut (G) and
4.
remove clevis (C) and then remove nut (G).
Carefully remove seals (H).
5.
NOTE
Your vehicle may or may not have
nuts on both sides of support (F).
6.
Using 1 inch wrench to hold support (F) use
15/16 inch wrench and remove nut and sha-
keproof washer (J).
7.
Using fingers, remove support (F) and nut
(K) from control cable (L).
Go on to Sheet 3
TA253852