MAGNETIC CLUTCH AND HOUSING REPLACEMENT (Sheet 6 of 6)
Remove electrician's tape from drive gear spline.
Place gasket (Z) on studs of housing (M).
When inserting magnetic clutch (E) in housing (M), make sure
legs of spider (W) slip in grooves of clutch.
Position and insert magnetic clutch (E) in housing (M).
Place new lockwasher (AA) on eight studs of housing (M).
Using 1/2 inch wrench, install eight nuts (AB).
Using allen wrench, install plug (AC).
Fill with lubricant (Item 43, Appendix D) at plug (AD) hole (LO 9-2350-222-12).
Using 3/8 inch wrench, install plug (AD).
End of Task