TM 9-2350-222-20-1-5
MAGNETIC CLUTCH AND HOUSING REPLACEMENT (Sheet 5 of 6)
6.
Using hammer and block of wood, install seal (L) in housing (M).
Using stud setter, install eight studs (N), if any
7.
were removed.
8.
Put gasket (P) on plug (Q).
Using 1-1/8 inch wrench, install plug (Q).
9.
10.
Using 7/16 inch wrench, install fitting (R).
11.
12.
Position gasket (U) and housing (M) with right angle drive (V).
13.
Using 1/2 inch wrench, install six screws (T).
14.
Make sure drive gear spline is still wrapped with electrician's tape. If not, wrap with three or
Position spider (W) in housing (M) on output spline of right angle drive.
15.
Place new lockwasher (X) on screw (Y).
16.
17.
Using 9/16 inch socket, install screw (Y) while
holding drive gear spline from turning with
pliers.
Go on to Sheet 6
TA141224
18-122