TM 9-2350-222-20-1-5
MOLDBOARD LOCKING HOOKS AND SHAFT REPLACEMENT (Sheet 2 of 6)
REMOVAL:
Using pliers, remove cotter pin (A) from pin (B).
1.
Throw cotter pin away.
2.
Remove pin (B) from clevis (C) and arm (D).
Using 3/4 inch wrench, loosen nuts (E) and
(F).
NOTE
It may be necessary to use
adjustable wrench to remove
bolts (G) and (H).
4.
Using 1/2 inch wrench, remove bolts (G) and
(H) from hooks (J) and (K). Remove nuts (E)
and (F) from bolts (G) and (H).
5.
Using sandpaper, remove about two inches of
paint from shaft (L) next to mounting
brackets (M) and (N).
6.
While one person holds brass drift, other person
using hammer, drive shaft (L) out of mounting
bracket (N).
7.
Remove hook (K) from bracket (N).
Go on to Sheet 3
TA141123