BULLDOZER BLADE ASSEMBLY REPLACEMENT (Sheet 8 of 11)
Attach hoisting device to lifting eyes (M) on top
edge of moldboard.
Extend pushbeams (A) toward vehicle.
Using hoisting device, lift moldboard until ends
of pushbeams (A) are at same height from
ground as mounting brackets on hull.
Lifting moldboard, slowly move moldboard
toward vehicle. Using personnel, move
moldboard from side to side until pushbeams
(A) are set onto brackets.
Install pin (N) into pushbeam (A) and bracket.
Apply lift and side to side movement as
Using 15/16 inch socket, install lock, new
lockwasher, and screw (P).
Go on to Sheet 9