BULLDOZER BLADE ASSEMBLY REPLACEMENT (Sheet 9 of 11)
If hydraulic system is not operating, lift moldboard until ram
arms are alined with pushbeams. After installing pins, lower
moldboard to ground.
Unfasten bands or straps on ram arms (Q) and lower ram arms (TM 9-2350-222-10).
Aline ram arms (Q) with pushbeam (A) and
install pivot pin (R) into pushbeam (A) and ram
Using 15/16 inch socket and 15/16 inch
wrench, install screw, new lockwasher, and lock
(S) into pushbeam (A) and pin (R).