TM 9-2350-222-20-1-5
DRIVER'S PERISCOPE BOX ASSEMBLY REPAIR (Sheet 1 of 2)
Electric drill
TOOLS: Hammer
Vise
3/16 in. drill bit
Alinement punch
Slip joint pliers
Pad (7992275)
SUPPLIES: Clean rags
Dry cleaning solvent (Item 54,
Pad (7992276)
Pad (7992277) (2 required)
Pad (7364662) (2 required)
Small brush
Stud (MS27977-8)
PERSONNEL: Two
PRELIMINARY PROCEDURE:
DISASSEMBLY:
1.
Remove strap (A) from box (B).
Using hans, pull unserviceable pads (C), (D),
2.
(E), (F), (G), and (H), as necessary, from inside of
box (B).
NOTE
Pad (G) must be removed before
stud (J) can be replaced.
NOTE
If stud (J) is broken off and cannot
be removed using pliers, use drill
to remove stud (J).
3.
Using pliers, remove stud (J) by pulling out and
moving back and forth.
CLEANING AND INSPECTION:
1.
Using dry cleaning solvent (Item 54, Appendix
D) and rags, wipe inside of
box (B) clean, as
necessary.
2.
Make sure areas inside box (B), where pads are
to be installed, are dry.
Go on to Sheet 2
TA139220