TM 9-2350-222-20-1-4
FRONT STEERING CONTROL ROD ASSSEMBLY REPLACEMENT (Sheet 3 of 3)
INSTALLATION:
Position rod and bearing assembly (A) to steering control lever(B) and lever (C).
1.
Install pin (D) and washer (E) to secure rod and bearing assembly (A) to steering control lever (B).
2.
Install washer (F) on pin(D) and using pliers, install new cotter pin (G) through hole in pin (D).
3.
4.
Using wrench, install bolt (H) to secure rod and bearing assembly (A) to link (C).
Check if steering control (J) is centered. If centered, proceed to step 8. If not centered, proceed to step
5.
6.
Insert locating pin (K) to lock lever (C).
6.
7.
Using wrench, remove bolt (H) and adjust rod end bearing (L) until steering control (J) is centered.
When steering control is centered use wrench and install bolt (H) to secure rod and bearing assembly
(A) to link(C). Remove locating pin(K).
8.
Using wrench position nut (M) up against rod end bearing (J). Using 9/16 inch crowfoot and torque
wrench, tighten nut (M) to 15-20 lb-ft (20-27 N- m).
9.
Using 9/16 inch crowfoot and torque wrench, tighten bolt(H) to 15-20 lb-ft (20-27 N. m).
TA253519
End of Task
Change 1 1 5-19/(1 5-20 blank)