STEERING CONTROL HANDLE AND SLEEVE MOUNT REPLACEMENT (Sheet 1 of 2)
9/16 in. combination box and open end wrench (2 required)
Slip joint pliers
Retaining ring pliers
Cotter pin (MS24665-283)
Lockwasher (MS35338-46) (4 required)
Disconnect front steering control rod assembly (page
Using wrenches on screw (A) and nut (B), remove four screws (A), nuts (B), and lockwashers (C) from
Remove mount (D) and steering handle (E) from vehicle.
Using slip joint pliers, remove cotter pin (F) from pin (G). Throw cotter pin away.
Using slip joint pliers, remove pin (G) and lever (H).
Using retaining ring pliers, remove retaining ring (J) from handle (E).
Using hands, remove handle (E) from mount (D).
Go on to Sheet 2
Change 1 15-15