TM 9-2350-222-20-1-4
ROADWHEEL ARM REPLACEMENT (Sheet 7 of 7)
8.
Position retainer (E) so that its jackscrew holes
are at top and bottom of upper spindle.
9.
Using pin punch, aline six mounting holes in
retainer (E) to holes in housing.
10.
mounting holes.
11. Using crowfoot wrench and torque wrench,
tighten six screws (G) alternately and evenly to
95-125 lb-ft (129-169 N.m).
12. Connect adjusting link at No. 1 roadwheel
13. Install shock absorbers if roadwheel arms were
removed from positions No. 1, 2, and 6 (page
TA141291
End of Task
14-8 Change 1