ROADWHEEL ARM REPLACEMENT (Sheet 4 of 7)
If roadwheel arm does not come out of support
housing (D) after repeated hits with slide
hammer. perform steps 7, 8, and 9.
Screw two 5/8-13 UNC threaded screws into
two retaining jackscrew holes,
Using 5/8 inch socket, alternately and evenly
Use slide hammer (F) while tightening
jackscrews, if used, to free arm from support
When arm is loose in support housing (D),
remove slide hammer (F) and adapter (E).
Using another person, remove roadwheel arm
and gasket to clean working area, Throw
Using internal puller (G), remove inner grease
seal (H) from support housing (D). Throw seal
13. Cover up opening in roadwheel support housing
so dirt will not get into housing (D).
Go on to Sheet 5