TM 9-2350-222-20-1-4
ROADWHEEL ARM REPAIR (Sheet 2 of 9)
DISASSEMBLY:
Using pliers, bend key washer tabs back out of
1.
slot in nut.
Using spanner wrench (Item 29.2, Chapter 3,
2.
Section I), loosen nut (A). Remove nut (A).
Remove key washer (B) and bearing washer (C).
3.
Throw bearing washer (B) away.
NOTE
Keep inner and outer races of bearings together as matched
set. If you throw away one race, throw away other one.
Use sleeve spacer (D) like a slide hammer to loosen inboard bearing (E). Remove bearing.
4.
Remove sleeve spacer (D) and outboard bearing (F).
5.
Pull oil seal retainer (G) off upper spindle (H).
6.
Go on to Sheet 3
14-10
Change 5