TM 9-2350-222-20-14
BRAKE RIGHT HAND SLAVE CYLINDER AND TUBE ASSEMBLY REPLACEMENT
of 6)
(Sheet
9.
Using fingers, position tube assembly (assembled in step 8) to tee (L) and slave cylinder (B).
10. Remove plastic cap from tee (L) and loosely connect tube assembly (G) to tee (L).
11.
Position two new gaskets (M), bolt (N), and end of tube assembly (H) as an assembly over hole in
slave cylinder (B).
Insert bolt (N) and tighten finger tight.
12.
13.
(34-40
Using torque wrench, tighten bolt (N) to 25-30
14.
Using adjustable wrench to hold tees (K) and (L), use 11/16 inch wrench and tighten nuts of tube
assemblies (G) and (H) tees (K) and (L).
15.
Using 11/16 inch wrench, tighten cap (J) onto tee (K).
over tube assembly (H)
16.
new
(R) on screw (S) and insert through
(Q)
17.
finger
tight.
.
18.
Using
inch socket, tighten screw (S).
TA253437
Go on to Sheet 6
1