BRAKE RIGHT HAND SLAVE CYLINDER AND TUBE ASSEMBLY REPLACEMENT
(Sheet 3 of 6)
Using 9/16 inch socket, disconnect mount-
ing nut (R) from stud.
Move slave cylinder (H) forward and
wiggle it side to side while pulling up until
catch clears housing assembly. Continue
this procedure until slave cylinder comes
loose from housing assembly.
Remove slave cylinder (H).
Using putty knife, remove packing (S)
from groove of slave cylinder (H) and
throw packing away.
CLEANING AND INSPECTION:
Clean all metallic parts in dry cleaning solvent (Item 54, Appendix D).
Inspect all parts for damage or wear. Replace all unserviceable parts.
Inspect tube assembly nut for cracks. Replace tube assembly if any are found.
Check bolt (F) for open and clean internal passages.
Go on to Sheet 4