BRAKE CONTROL HOUSING REPAIR (Sheet 3 of 14)
Using pliers, remove cotter pin (C). Throw
cotter pin away.
Remove pin (D) by pulling out. Remove push
Using pliers, pull pin (F) from housing clevis
Using two 9/16 inch wrenches, remove two nuts
(H) by removing lower nut first while holding
Move lever assembly (J) clear of control
assembly and remove two washers (K) and
Using retaining ring pliers, remove snapring
Slide lever (N) off shaft (P) and remove lever
(N) and lever assembly (J) with attached parts
from control housing.
Go on to Sheet 4