TM 9-2350-222-20-1-4
PARKING BRAKE PAWL AND BELLCRANK ADJUSTMENT (Sheet 7 of 9)
CAUTION
Do not allow shaft to turn or damage to control will result.
17.
Remove spring from pawl, using two 9/16 inch wrenches, loosen two nuts (R) and (S) on end of shaft
(K).
Push or pull shaft (K) until 1-1/8 inch gage block just fits between cotter pin (M) and sleeve nut (J).
18.
With gage block in place, rotate upper nut (R) until there is metal to metal contact between upper nut
19.
(R) and lever assembly (T).
Using 9/16 inch wrench, back off upper nut (R) 1-1/2 turns.
20.
21.
Using two 9/16 inch wrenches, hold nut (R) and lock lower nut (S securely against upper nut (R) and
install spring on pawl.
Remove gage block and go to step 31.
22.
Go on to Sheet 8
TA253422
13-18.4 Change 1