PARKING BRAKE PAWL AND BELLCRANK ADJUSTMENT (Sheet 6 of 9)
Do not allow shaft to turn or damage to control will result.
Using two 9/16 inch wrenches, loosen two nuts (R) and (S) on end of shaft (K).
Push or pull shaft (K) until a 15/16 inch gage block fits between cotter pin (M) and bottom face of
sleeve nut (J).
Adjust upper nut (R) to allow a 3/16 inch gage block to be placed between the lower face of lever (T)
and upper nut (R).
Using two 9/16 inch wrenches, hold nut (R) and lock lower nut (S) securely against upper nut (R).
Remove gage blocks and go to step 31.
Go on to Sheet 7
Change 1 13-18.3