TM 9-2350-222-20-1-4
ELECTRICAL WIRING HARNESS AND CABLE CONNECTOR REPAIR
TERMINAL CONNECTOR REPAIR (Sheet 2 of 2)
Slide new heat-shrink tubing (D) onto and back
4.
along cable (C).
Slide new terminal (B) over stripped cable end
5.
(E) and onto cable (C).
6.
Using crimping tool, crimp terminal (B) at
(F) and (G).
Slide heat-shrink tubing (D) over crimps (F) and
7.
(G).
Using heat gun, shrink tubing (D).
8.
9.
circuit.
10. Tighten or install cable clamps as required.
11. Connect three battery ground straps (page
End of Task
TA139865
10-314