TM 9-2350-222-34-1
RIGHT ANGLE DRIVE POWER TAKEOFF REPAIR (Sheet 6 of 10)
ASSEMBLY:
1. Using arbor press, install two bearings (A) (if
removed) in housing (B). Bearing must be
pressed all the way in flush with face of housing
bore.
2. Using pliers, install pin (C) in retainer (D).
3. Using arbor press, install bearing (E) in retainer
assembly (F) until it clears retaining ring groove.
4. Using snap ring pliers, install retaining ring (G).
5. Using arbor press, install retainer assembly (F),
with its assembled parts, on gear shaft (H) until
it clears retaining ring groove on shaft.
6. Using snap ring pliers, install retaining ring (J).
NOTE
Make sure threads of retainer assembly (F)
and those in housing are clean.
7. Thread retainer assembly (F) into housing (B).
Insert screwdriver between flange and pin of
retainer assembly. Using screwdriver as a lever,
tighten retainer assembly until it is flush with face
of housing.
TA130876
Go on to Sheet 7
12-53
