TM 9-2350-222-34-1
MAGNETIC CLUTCH ADJUSTMENT (Sheet 1 of 2)
TOOLS:
Power supply (28 vdc)
9/64 in. socket head screw key (alien wrench)
Thickness gage, 0.015 to 0.018 inch (brass)
REFERENCE: TM 9-2350-222-20-1
SUPPLIES:
Pencil and paper
PRELIMINARY PROCEDURE:
Remove magnetic clutch (TM 9-2350-222-20-1)
ADJUSTMENT:
1. Connect positive lead of power supply to pin in
connector (A) and ground lead to rim of magnet
body half (B).
2. Turn on power supply and adjust for 26.5-30
vdc.
3. Using thickness gage, measure and record air
gap between magnet body half (B) and clutch
body half (C) at four points (top, bottom, and
both sides).
4. Add up the four gap measurements, then divide
by four to get average. Average should be
0.015 to 0.018 inch for proper adjustment. If
not, proceed to step 5.
Go on to Sheet 2
TA130881
12-58