TM 9-2350-222-34-1
HYDRAULIC PUMP DISCHARGE TUBES ASSEMBLY REPLACEMENT (Sheet 2 of 7)
REMOVAL:
NOTE
Removal procedures for cover
end
tube assembly (A) and shaft end
tube
assembly (B) are identical.
This
procedure describes cover end
tube
assembly.
NOTE
Retaining straps C, D, and E are
identical.
1. Using 9/16 inch socket, remove two screws and
lockwashers (F) from two retaining straps (C)
and (D). Upper half of retaining straps will come
off with screw and lockwasher (F). Lift tube to
remove lower half.
2. Using 9/16 inch socket, remove screw and
lockwasher (G) from retaining strap (E). Lift tube
to remove lower half of strap.
NOTE
Steps 3 thru 8 must be performed in
crew compartment.
3. Using 1-5/8 inch wrench to hold adapter (H) and
1-1/2 inch wrench on nut (J), remove nut (J)
from adapter (H).
4. Have two persons in engine compartment pull
discharge tube (A) away from adapter (H).
Go on to Sheet 3 TA130865
12-42
