TM 9-2350-222-34-1
HYDRAULIC RESERVOIR SUCTION LINE ASSEMBLY REPLACEMENT (Sheet 6 of 7)
5. Position clamp (H) onto upper end of suction line
(A).
6. Using fingers, install 1-1/2 inch long screw (J),
two flat washers (K), and nut (L) onto clamp (H).
Tighten finger tight.
7. Using fingers, install 2-1/4 inch long screw (M),
two flat washers (N), nut (P), and jamnut (Q)
onto clamp (H). Tighten finger tight.
8. Position clamp (H) onto hull mounting boss and,
using 3/4 inch wrench, thread screw (M) about
seven or eight complete turns into mounting
boss.
9. Using one 3/4 inch wrench to hold screw (M) and
other 3/4 inch wrench on jamnut (Q), tighten
jamnut against hull mounting boss.
10. Using one 3/4 inch wrench to hold screw (M) and
other 3/4 inch wrench on nut (P), tighten nut (P).
11. Using one 3/4 inch wrench on screw (J) and
other 3/4 inch wrench on nut (L), tighten screw
(J) and nut (L).
Go on to Sheet 7
TA130863
12-39
