TM 9-2350-222-34-1
HYDRAULIC RESERVOIR SUCTION UNE ASSEMBLY REPLACEMENT (Sheet 5 of 7)
INSTALLATION:
1. Using three persons, position new suction line
assembly (A) into vehicle. Light up area under
turret so hole in bulkhead can be seen.
2. Using screwdriver, install seal (A.1) on bushing
(B).
2.1. Install seal (A.1) and bushing (B) over end of
suction line (A) into bulkhead mounting block.
Using spanner wrench, tighten bushing (B) in
bulkhead mounting block (B.1).
NOTE
Use one person to raise and lower
suction line while installing straps.
3. Using fingers, install strap (C) onto suction line
(A) and hull mounts with two screws,
Install
screws loosely.
4. Using fingers, install two straps (E) and (F) onto
suction line (A) and hull mounts with two screws,
NOTE
lockwashers, and flat washers (G) in each strap.
Straps C, E, and F are identical
Install screws loosely.
Go on to Sheet 6
Change 3
12-38
