TM 9-2350-222-34-1
REAR DRAIN VALVE FRONT CONTROL ROD REPLACEMENT (Sheet 2 of 4)
NOTE
To perform step 3, pin (E) must be in straight up position. If pin (E) is not in straight up position,
remove rod end from clevis at engine compartment drain valve (page 11-25, steps 1 and 2) and
turn rod (F) so pin (E) is in straight up position.
3. Go to turret and find pin (E) in universal joint (G).
4. Using hammer and welding rod, drive pin (E) out of
universal joint (G). Throw pin away.
5. Open engine compartment drain valve (TM 92350-222-
10).
6. Go to driver's compartment and using hands,
remove rod assembly (H) from under turret
floor. Carry rod assembly (H) to vise.
Go on to Sheet 3
TA130807
11-10