TM 9-2350-222-34-1
MASTER CYLINDER-TO-BULKHEAD TUBE ASSEMBLY REPLACEMENT (Sheet 3 of 4)
3.
Using wrench, remove tube nut (D) from
bulkhead union (E).
(Located in turret
compartment.)
4.
Using socket, remove three screws, washers.
and loop clamps (F), holding tubing to hull wall.
5.
Remove tubing (G) from vehicle.
6.
Check loop clamps
(F)
for
serviceability.
Replace as required.
INSTALLATION:
1.
Position tubing (A) in vehicle.
NOTE
Start tube nuts by hand first.
2.
Using wrench, install tube nut (B) to bulkhead
union (C).
Go on to Sheet 4
TA130739
8-9
