TM 9-2350-222-34-1
TRANSMISSION REPLACEMENT (Sheet 23 of 24)
63. Position bracket (CH) onto stud (CJ) and, using
1/2 inch wrench, install nut and washer (CK)
onto stud (CJ).
64. Using pliers, install new cotter pin (CL) through
stud (CJ).
65. Using two 9/16 inch wrenches, tighten screw
(CM) and nut (CN) onto bracket (CH).
66. Position bracket (CP) and rod (CQ) onto
transmission as a unit.
NOTE
It may be necessary to move stud (CV)
67. Using 3/4 inch socket, install washers (CR) and
back
to
original
position
to
nuts (CS) securing bracket (CP) to transmission.
accommodate nut (CU) and washer
(CT).
68. Using 3/4 inch socket, install washer (CT) and nut (CU) onto stud (CV).
Go on to Sheet 24
TA130712
6-44