TM 9-2350-222-34-1
ENGINE ACCESSORY HARNESS ASSEMBLY REPLACEMENT (2A ENGINE) (Sheet 2 of 4)
NOTE
Strap type clamps should be left in place
by removing only one screw. If replace-
ment of strap is required, remove both
screws.
5. Using 7/16 inch wrench, remove screw (D),
lockwasher (E), and flat washer (F) from strap (G).
6.
Using 7/16 inch wrench, remove screw (H) and
lockwasher (J) which is hidden by bulkhead.
7. Remove clamp (K).
8. From engine compartment, using 7/16 inch wrench,
washers (N) from straps (P).
9. Remove engine accessory harness from vehicle.
Go on to Sheet 3
TA130637
5-58