TM 9-2350-222-34-1
REAR ACCESSORY WIRING HARNESS REPLACEMENT (Sheet 6 of 8)
INSTALLATION:
1. Position harness (A) into vehicle as shown.
2. Install clamp (B), two lockwashers (C) and (D), terminal connector (E), and screw (F). Using 7/16 inch
socket, tighten screw.
3. Install three clamps (G), lockwashers (H), and screws (J). Using 7/16 inch socket, tighten screws.
4. Install six clamps (K), lockwashers (L), and screws (M). Using 7/16 inch socket, tighten screws.
5. Install seven clamps (N), lockwashers (P), and screws (Q). Using 7/16 inch socket, tighten screws.
6. Install 10 clamps (R), lockwashers (S), and screws (T). Using 7/16 inch socket, tighten screws.
Go on to Sheet 7
TA130633
5-54
