TM 9-2350-222-34-1
ENGINE ACCESSORY HARNESS ASSEMBLY REPLACEMENT (2D ENGINE) (Sheet 2 of 5)
NOTE
Strap type clamps should be left in
place by removing only one screw. If
replacement of strap is required,
remove both screws.
5. Using 7/16 inch wrench, remove screw (D),
lockwasher (E), and flat washer (F) from strap
(G).
6. Using 7/16 inch wrench, remove screw (H) and
lockwasher (J) which is hidden by bulkhead.
7. Remove clamp (K).
8. From engine compartment, using 7/16 inch
wrench, remove two screws (L), lockwashers
(M), and flat washers (N) from covers (P).
9. Using 7/16 inch wrench, remove screw (Q),
lockwashers (R) and flat washer (S) from cover
(T).
Go on to Sheet 3
TA130641
5-62
