TM 9-2350-222-34-1
HEATER CONTROL WIRING HARNESS ASSEMBLY REPLACEMENT (Sheet 2 of 5)
2. Disconnect connector (C) from personnel heater fuel pump lead (D) by pulling apart.
3. Using 7/16 inch wrench on nut (E} behind plate (F), and socket on screw (G), remove screw (G), lockwasher (H), lead
(J), flat washer (K), clamp (L), dummy housing (M), lockwasher (N), and nut (E) from plate (F). Loosely replace
dummy housing with screw, washers, and nut. Remove lead (C) from clamp (L). Do not remove clamp (L) from
harness.
Go on to Sheet 3
TA130617
5-38
