TM 9-2350-222-34-1
HULL POWER WIRING HARNESS ASSEMBLY REPLACEMENT (Sheet 9 of 14)
2. Using spanner wrench, connect connector (A) to
master control panel (B).
3. Install bilge pump connector onto dummy shell (TM
9-2350-222-20-1).
4. Install clamp (C) onto wiring harness.
5. Using 7/16 inch wrench and socket, install clamp
(C) onto plate (D) with screw and lockwasher (E)
and nut (F).
6. Install clamp (G) onto wiring harness.
7. Using 7/16 inch wrench and socket, install screw
and lockwasher (H, and nut (J) into clamp (G).
Go on to Sheet 10
TA130610
5-31
