TM 9-2360-222-34-1
FUEL PRIMER OUTLET FROM ENGINE TUBE ASSEMBLY REPLACEMENT (EARLY MODEL)
(Sheet 2 of 6)
NOTE
Gain access to rear of bulkhead
through left access opening (H)
located in turret compartment.
3. Using 9/16 inch wrench, reach through access
opening (H) and disconnect front nut (J) of tube
(D) from nipple (K).
4. Using 7/16 inch socket, remove screw (L) and
lockwasher (M) holding front clamps (N) to
clamp mount. Throw lockwasher away.
5. Remove tube (D) through engine compartment
by passing rear end of tube behind primer inlet
tube (P) and clamp (Q).
6. Remove clamps (C), (G), and (N) from tube (D).
Go on to Sheet 3
TA252594
Change 1 4-75
