TM 9-2360-222-34-1
FUEL SHUTOFF CABLE ASSEMBLY REPLACEMENT (Sheet 4 of 6)
INSTALLATION:
1. Tie driver's compartment end of wire (A) to one
end of cable assembly (B).
2. Apply a thin coat of silicone compound (Item 10,
(B).
3. Pull cable assembly (B) through bulkhead
housing (C).
4. Remove wire (A) from cable (B).
5. Install grommet (D) over cable (B).
6. Tie wire (A) to cable (B).
7. As one person pulls wire in engine compartment,
have another person guide cable assembly (B)
through bulkhead housing (C).
8. After cable assembly has been threaded into
place, remove wire (A).
9. Install new packing (E) and nut (F) onto cable
assembly (B) and slide up to bulkhead housing
(C)
Go on to Sheet 4.1
TA252590
4-72 Change 1
