TM 9-2350-222-20-2-3.2
36-69. CUPOLA AZIMUTH LOCK ASSEMBLY PROCEDURE (CONT)
FRAME 1
Procedure
Step
Place plunger (1) in azimuth lock (2).
i.
Using screwdriver, tighten plunger (1) until gear rack (3) is held in up or down position.
2.
Move gear rack (3) from up position to down position to make sure it does not bind.
3.
4.
Put locking nut (4) on plunger (l).
Using screwdriver to hold plunger (1), use wrench to tighten locking nut (4).
5.
NOTE
If there is binding in step 6, loosen locking nut (4).
Unscrew plunger (1) 1/4 turn and repeat steps 5 and 6.
Move gear rack (3) from up position to down position to make sure it does not bind.
6.
GO TO FRAME 2
Para 36-69 Cont
36-157
