TM 9-2350-222-20-2-3-2
36-62. CUPOLA AZIMUTH GEAR BOX INSTALLATION PROCEDURE
TOOLS: 9/16" socket (3/8" drive)
6" extension
3/8" drive ratchet
PERSONNEL: One
REFERENCES: TM 9-2350-222-10 for procedure to traverse cupola
EQUIPMENT LOCATION INFORMATION:
CALLOUT
FOLDOUT
EQUIPMENT
11
Driver's Master Control Panel
7
Turret Traverse Lock
17
Cupola Azimuth Gear Box
EQUIPMENT CONDITION: Driver's master control panel MASTER BATTERY switch set to OFF
Turret traverse lock set to LOCKED
Procedure
Step
Place one spring (1), with small end facing out, on top mounting stud (2).
1.
Place cupola azimuth gear box (3) on mounting studs (2).
2.
Place two springs (l), with small end facing out, on lower mounting studs (2).
3.
4.
Place three flat washers (4) on mounting studs (2).
NOTE
Tighten nuts in step 5 until gears mesh.
5.
Using socket wrench, attach cupola azimuth gear box (3) to cupola with three nuts (5).
MOTE
Follow-on Maintenance Action Required:
Traverse cupola to check cupola azimuth gear box for
proper operation (TM- 10).
END OF TASK
Para 36-62
36-144
